How To Repair Pressure Cooker

Introduction

This is how the re-assembled steamer will wait - notice how the locking machinery is fix up to work correctly

Set your handle items in front of you

Ready your handle items in front end of you

Take the metal plate (when you removed the gasket, you will have to put it on again; when you removed the valve, you have to pull the rubber part through the hole first, so that the groove covers the metal, then assemble the plastic part) and the black fork.

Take the metal plate (when you lot removed the gasket, you volition accept to put information technology on again; when you removed the valve, y'all take to pull the rubber part through the pigsty first, and then that the groove covers the metal, then assemble the plastic part) and the blackness fork.
Pull the fork through the pigsty in the rubber gasket and push it under the square plastic part with the spring.
Alert: The fork has a curved side which MUST bespeak towards the spring (not towards the metal). The curved side of the foursquare part must lean on the fork, as you lot can see in picture 3. When y'all do this step wrong, you lot will find that the valve won't close.

Take the metal role and the plastic handle
The bound should be placed in the knob (see flick with green circle)
Y'all may have to movement the metal part a bit to the forepart so that it slides in correctly. Pay attention to the gasket, information technology should stay in it's place.
Insert both screws and tighten them.

From the 4 parts, take the Z-shaped one (Top right) and place it with the more slim flap into the notch of the black fork.
Then you can lay the metal chip into the notch left.

Now you can join the orange office with the leap and the metal scrap which belongs to it (As seen in the picture).
After that, push the metal bit in the notch and press the spring behind the small metal chip.
If the Z-shaped office disturbs you at this betoken, pull it back while pressing on the valve. WARNING: While you are pulling, the part may slip out of the fork. To check, slide the valve once more frontward, the pocket-size black valve should now lift upwardly.

Place the black plastic part with the spring in the notch.
Afterward that, you can slide the metal part under information technology.
Finally, y'all take to place the slider onto the metallic flake and then that it fits onto the knob.

Lay the lid onto the handle, as seen in the picture.
The slider should exist moved to the "closed"-position and the metal scrap should connect with the Z-shaped office.
Place the screws in the right position and tighten them. Finished!
It would be skillful to exam if the lid closes right. Fill some water into the pot, place and fasten the lid, turn on the stove and expect for the valve to close.